When working on projects for the raspberry pi, it’s sometimes needed to have the screen be rotated, we need to go and modify the boot config of the raspberry pi.
A while ago I picked up a Davinci XYZ 1.0A 3D printer. I mostly bought this for three reasons:
- Ease of use as I was just getting into 3d printing and wanted something that would be a good step to start printing what I wanted. This is done w/ filament cartridges that know what type of material it is and configures the printer accordingly.
- 7.8″ cubed print bed, this was the larger printer volume on the market for the price.
After a few mediocre prints, I found out what some of the complaints were about. First is the EPROM chip in the filament cartridges. This seems like a bonus at first, but after you realize the cost per kg of the filament, you realize the price is obnoxious. You are forced into using their proprietary filament which is limited and expensive. There are ways around this like an EPROM resetter using an arduino.